ARCHON D11V(W17V) XM-L LED Max 860 Lumens Underwater Photographing light diving Flashlight Diving Equipments Diving lamp

ARCHON Authorized Sales

◆Model:D11V/W17V Underwater Photographing Light  

◆Bulb: Cree XM-L (Max 860 lumens) 

◆Color temperature: 5000k.

◆Three output levels. High> Low>Strobe

◆Runtime: High: 70min, Low: 320 min, Strobe: 150 min 

◆Reflector: without reflector, for underwater photographing only

◆Lens: 4mm Polycarbonate Board.

◆Body material: Durable aircraft-grade aluminum.

◆Angle of light beam: 110°

◆Surface treatment: Premium Type III hard-anodizing.

◆Color: Black

◆Battery: CR123*2 or 18650 Li- ion battery *1.

◆With battery over-discharging protection, polarity reversing protection

◆Operation voltage: 3V to 6V.

◆Waterproof: 100 meters underwater

◆Dimensions: 125(length)*24(dia. of body)*40mm (dia. of head).

◆Weight: 140grams (without battery); 190 grams (with battery)

◆Underwater Weight: 95 grams (with battery)

◆Impact resistance: 1.5M.

BATTERY INSTALLATION

1.       Remove the tail by turning counter-clockwise.

2.       Remove used battery and replace with fresh batteries as shown by the polarity stickers.

3.       Mount the tail by turning clockwise. DO NOT ACTIVATE IT YET.

BATTERY CHARGING

1.       Plug the charger in the wall power socket, the indicator light is green in the free-load status.

2.       Put the battery in the slot of the charger.

3.       The indicator light is red if the battery is not fully charged; it will turn green after fully charged.

4.       Take out the fully charged battery and use them in the diving light.

ON/OFF

Turn the tail clockwise until the light activates. DO NOT OVERTIGHTEN.

To turn the light off, back off the tail counter-clockwise until the light goes off.

Continue to back off for approximately one full turn to eliminate the possibility of the light activating accidentally in storage. For underwater use, backing off too much will allow water to enter past the o-ring.

MODES CHANGING

Successive switch ON-OFF within two seconds to cycle through high, low, strobe.

SCUBA DIVING APPLICATION

Check closely for cuts, scratches, or an otherwise damaged o-ring or mating lens surface as this can cause the light to flood under pressure. Remove any salt deposits, sand, dirt, or other foreign matter from the o-ring sealing surfaces.

KEEP THE THREADS, O-RING GROOVE LUBRICATED WITH SILICONE GREASE.

CAUTION

If the light is not to be used for some time, remove the battery to prevent possible leakage or corrosion. Please remove the battery during transportation to prevent it from misoperation.